Duplicate / Clone Type remote control Malaysia.

Compatible with Chip model of SMC5326 AX5326 PT2262 PT2264 SC2262 SC2260 HS2262 2260 LX2262 2260 2264, 2260, 2262, 1527, FP527, 2240, SMC918 (Please double check chip in your remote before purchase). EV1527 PT2240 , with or without 8 code switch.

Please confirm you are using frequency 330 or 433Mhz remote before purchase.

*Setting method: Copy

*Battery: 12V 23A

*Product packaging: 1* remote control (including battery)

Instructions:

<!--[if !supportLists]-->1. <!--[endif]-->Clear the code: press the two buttons on the top with two fingers at the same time, the LED light will flash quickly for about 2 seconds, and then release, (how to know whether the code clearing is successful: press one of the remote control buttons, when the LED light is a When it flashes and then goes off, it means that the code is cleared successfully, and the four buttons are empty; if the light is still on after pressing any key on the remote control, it means that the original code has not been cleared successfully. You must clear and successfully clear the code again to successfully clone the code. .You can clean and clone the code repeatedly.)

<!--[if !supportLists]-->2. <!--[endif]-->Copy: Use the original remote for the left hand and our cloned remote for the right, and the two remotes are as close as possible. Press the buttons of the remote control at the same time (each button is copied separately), the LED flashes quickly, after about 2 seconds, release your finger. Then press the button, after the learning is successful, the light will be on, indicating that the first key code on the original remote control has been copied to another remote control. The same method can copy the second button, the third button... If the copy is successful, the remote control function is the same as the original paired remote control.

<!--[if !supportLists]-->3. <!--[endif]-->Recovery: Note that when you accidentally clear the remote control password, you can press the two buttons at the bottom of the remote control at the same time, and the LED will flash quickly. After releasing, the LED will light up to indicate that the password has been restored.